al roller_sensor rs Trendsetter_400/800_Auto Trendsetter_NEWS When set, (1), this flag enables checking of the roller position sensor. This sensor is also used to ensure that the roller is not in the "no fly" zone before spinning the drum. When cleared, (0), the sensor is by-passed and timeouts are used instead. byte

1

0 to 1

If this flag is cleared, (0), machine operation is significantly slowed down and some critical safety checks are not done. Clearing this flag should only be done on a temporary basis and the sensor should be repaired as soon as possible. Please do not clear this flag unless absolutely necessary! This flag was previously named "nrs" in other products. cal

../commands/engine.xmlCommand: engine

../nvs/aldly_cal_roller.xmlNVS: aldly roller

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:35:41 2008 PST